Installation Is Easy

The Standard Spa and Turbo systems consist of only two components, an electrical control box that plugs into a standard 110V or 220V outlet and a clear PVC chamber that is installed in the return line to your pool or spa from the filter or pump. The system can easily be installed in less than 30 minutes. The only work involved is cutting a small section of the PVC pipe out of the line that runs back to your pool or spa and gluing two fitting on the ends of the pipe that was cut. The chamber is then screwed hand tight onto the fittings.

The ionization/oxidation chamber in spas is installed in the water line used by the recycling pump. The controller is wired to the spa electrical service panel that is available for an ozonator. If the ECOsmarte System is being used to replace an ozonator, the system can be wired using the plug attached to the ozonator. ECOsmarte technicians can provide guidance for installation on hundreds of different spa models and manufacturers and are available six days a week to provide toll-free support. In review:

• Determine Electrical Connection
• Cut PVC Pipe Section
• Glue ECOsmarte Fittings
• Install Chamber onto Fittings Hand Tight
• Hang Control Box and connect to Electrical
• Call your ECOsmarte Tech for guidance if required